|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 22nd 04, 06:45 AM
|
|||
|
|||
Any suggestions on how to remove waterproofing
I'll try again,
Any suggestions on how to remove a good dose of waterproofing (non silicon) from a fiberglass and resin (vinyl Ester) lay-up? Can it be done safely and with no lasting, or long term aftereffects? This is inside the horizontal stab where strength is pretty important. I'm to the point of installing the hinges, or pitching it and starting over if I can't clean it to the point where I'm satisfied future bonds will be secure under high stress. Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Product to remove oil stains from concrete for painting? | Scott | Home Built | 17 | September 15th 04 06:31 PM |
| Remove oil seal from vacuum pump adapter on Lycoming IO320 HOW????? | Ron | Home Built | 2 | February 24th 04 04:34 PM |
| Need suggestions for clean butt splice for electrical wires. | Bart D. Hull | Home Built | 9 | January 30th 04 04:28 AM |
| Plan Suggestions | Bill A. | Home Built | 2 | January 9th 04 07:27 AM |
| Builder's Insurance Suggestions | Evan Carew | Home Built | 12 | October 9th 03 06:53 AM |
Threaded Mode