|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 12th 08, 12:36 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
instrument panel material
What is the typical material for an instrument panel?
Soft steel sheet, I should think? What thickness? Have I understood some designs have the panel as an integral part of the fuselage, contributing to its strength/stiffness? But that would be fibre (epoxy/carbon) planes, no? TIA, 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Instrument Panel | ccwillwerth | Home Built | 7 | February 9th 06 03:15 PM |
| DG-300 instrument panel | [email protected] | Soaring | 14 | January 29th 06 03:48 PM |
| LS 6 b instrument panel | John Brenann | Soaring | 4 | November 19th 05 05:37 AM |
| Instrument Panel Paint | [email protected] | Owning | 0 | May 1st 05 03:54 PM |
| ASW20A instrument panel available | goneill | Soaring | 1 | November 2nd 04 09:32 AM |
Threaded Mode