![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I used EAR Specialties Confor foam in my plane's seats. I laminated the
three softest 1/2" plies behind my back with a lumbar piece, all four 1/2" ply grades under my legs, and five 1/2" plies under my butt; two of the hardest, two of the next softer, and one of the next softest. Even with a wallet in my back pocket there are no pressure points, which on my five and six hour x-country flights is a real blessing! Look on McMaster-Carr catalog page 3304, www.mcmaster.com. They get hard when cold, but will soften and conform as your bod warms them up. I highly recommend this foam for your seats if you do much long-endurance flights. I think McMaster's prices are less than you'll find in ACS. Several of us went together to buy them through the factory to meet their minimum purchase amount. EAR also has a complete line of sound-absorbing material for aircraft, and a booklet on their use. |
#2
|
|||
|
|||
![]() ELIPPSE wrote: I used EAR Specialties Confor foam in my plane's seats. I laminated the three softest 1/2" plies behind my back with a lumbar piece, all four 1/2" ply grades under my legs, and five 1/2" plies under my butt; two of the hardest, two of the next softer, and one of the next softest. Even with a wallet in my back pocket there are no pressure points, which on my five and six hour x-country flights is a real blessing! Look on McMaster-Carr catalog page 3304, www.mcmaster.com. They get hard when cold, but will soften and conform as your bod warms them up. I highly recommend this foam for your seats if you do much long-endurance flights. I think McMaster's prices are less than you'll find in ACS. Several of us went together to buy them through the factory to meet their minimum purchase amount. EAR also has a complete line of sound-absorbing material for aircraft, and a booklet on their use. Not only is McMaster-Carr a good source for the Confor foam, it is an great source for the sound-absorbing material. I got a super light weight sound absorbing foam for lining my interior from McMaster-Carr. The stuff is self-extinquishing and gives off no toxic gases. I got a roll of 1/8 inch and 1/4 inch which only weight a couple of pounds per roll. Check them out and be prepared to take delivery when you order. In most cases, my orders from McMaster-Carr were delivered within 24 hours of placing the order. |
#3
|
|||
|
|||
![]()
In most cases, my orders from McMaster-Carr were delivered within 24
hours of placing the order. Grainger is a company very much like McMaster-Carr, except they have a warehouse about 20 miles from me. The closest McMaster-Carr is an 8 hour drive. I nearly always get McMaster-Carr orders the next day, but Grainger orders take 3. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need Source for Slip-On Foam Yoke Grips | Carl Orton | Owning | 6 | February 28th 04 04:22 AM |
blue foam & cutting it | Richard Riley | Home Built | 6 | November 24th 03 01:53 PM |
Seat repairs | mikem | Owning | 2 | October 10th 03 09:25 PM |
I wish I'd never got into this... | Kevin Neave | Soaring | 32 | September 19th 03 12:18 PM |
blue foam, pink foam, yellow foam? | Corrie | Home Built | 26 | September 1st 03 05:01 PM |