|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 6th 10, 10:43 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
O200 reassembly
hello,
I will begin the engine final assembly. I read I need to begin with the 3 dowel screws and the front two 7/16 through studs and low rear3/8 stud. I don't find the tight order after that. I guess it is better to tight all the stud nuts on big machined washer before the sealant cure and fit the cylinders next day. I own and read the overhaul manual. If I don't find any order, I will begin with center bearing, rear bearing next and remaining front bearing nuts. At the end, all the flange bolts. Thanks for any help -- http://www.youtube.com/v/k6AP4SbRHNo...s=1&rel=0 Philippe Vessaire Ò¿Ó¬ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C85 and O200 piston | Philippe[_4_] | Home Built | 2 | August 11th 10 06:47 PM |
| O200 overhaul | Philippe[_4_] | Home Built | 0 | May 30th 10 09:38 PM |
| O200 cylinder | Philippe Vessaire[_3_] | Home Built | 3 | October 19th 08 12:21 PM |
| O200 engine | Philippe Vessaire | Home Built | 7 | August 17th 07 09:53 PM |
| O200 nose | Philippe | Home Built | 0 | July 22nd 05 09:09 PM |
Linear Mode
