![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
does anyone have a B-4 tail dolly excess to their requirements?
Ours seems to have been run over by a youth member. if you do, please reply wit $ requirement r/Jim |
#2
|
|||
|
|||
![]()
If it is fiberglass, a repair should not be a big deal even if it is nearly destroyed. Where are you located?
|
#3
|
|||
|
|||
![]()
On Saturday, July 25, 2015 at 7:14:36 PM UTC-4, wrote:
If it is fiberglass, a repair should not be a big deal even if it is nearly destroyed. Where are you located? Was run over by a pick up truck. initial repair failed because of lack of supervision, imo. A new one is 450E, 495USD+ship. Suspect any attempt to repair will exceed the cost of new. So, that being said, anyone have a B-4 tail dolly gathering dust? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tail dolly for 1-35? | [email protected] | Soaring | 5 | October 22nd 13 11:14 PM |
LS4 tail dolly | Leigh | Soaring | 0 | May 30th 08 02:02 AM |
ASK-21 - is a tail dolly necessary? | Dave Springford | Soaring | 7 | December 31st 07 08:43 AM |
WTB: used tail dolly | David Campbell | Soaring | 5 | April 17th 06 03:19 PM |
L-23 tail dolly | Mark Zivley | Soaring | 1 | November 27th 04 11:16 AM |