|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#21
October 27th 03, 05:06 AM
|
|||
|
|||
Um, no. The wing, when one tire goes flat and the other is inflated normally,
comes within a quarter-inch of a 2x2 steel beam in the hangar roof. Another quarter of an inch and I'll have a wing to replace some day. Not a good idea, at least not for me. Jim (Ben Jackson) shared these priceless pearls of wisdom: -How unlevel is it? Just make yourself a really shallow ramp (say by -ripping strips of 1/4" masonite and stacking/gluing them). Put that -on the hangar floor so that you roll onto it as you park. Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spaceship one | Pianome | Home Built | 169 | June 30th 04 05:47 AM |
| Fuel Drip Containment -- My Solution | Jim Weir | Home Built | 4 | November 1st 03 05:22 AM |
| Fuel Drip Containment | Sven | Home Built | 28 | October 27th 03 10:28 PM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 02:57 AM |
| Pumping fuel backwards through an electric fuel pump | Greg Reid | Home Built | 15 | October 7th 03 07:09 PM |
Threaded Mode