|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 15th 04, 04:58 AM
|
|||
|
|||
Reinstalling vacuum DG
I finally pulled my Mitchell (Edo-Aire?) vacuum DG and sent it off to
Bernard Ducasse for overhaul. For those following the new vs. re-new debate, I'll let the group know how the overhaul turns out. After removing the DG, I covered the exposed ends of the vacuum hoses left dangling in the plane with plastic and did the same to the exposed ports on the DG. Any advice on special things to do during the re-installation to protect the new gyro? Regards, Mike http://mywebpage.netscape.com/amountainaero/fspic1.html 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wet vs Dry Vacuum Pump | Fastglasair | Home Built | 1 | December 15th 04 05:17 PM |
| Wet Vacuum Pumps | DBlumel | Home Built | 4 | August 19th 04 08:27 AM |
| Reverse Vacuum Damging to Instruments? | O. Sami Saydjari | Owning | 8 | February 16th 04 04:00 AM |
| Can vacuum AI be removed if a certified electric one is installed?? | Dave | Owning | 11 | January 12th 04 06:08 PM |
| Low vacuum at idle | Chad Lemmen | Owning | 1 | August 18th 03 09:24 PM |
Threaded Mode