|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
February 17th 04, 06:51 PM
|
|||
|
|||
"Scott" wrote in message ... If I cut Lexan on a bandsaw, what is the best way to sand out the cut marks along the cut line? Sand paper? File? I want to make a new windshield and the cut edge will be the top of the windshield (open cockpit). Are you sure you want to use polycarbonate rather than acrylic? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| best cutting fluid/oil/paste 2004..... theory and practice? | B2431 | Home Built | 1 | January 20th 04 07:27 PM |
| Cutting sheet steel | Ernest Christley | Home Built | 28 | November 28th 03 07:58 PM |
| air drill question | Ded Dog | Home Built | 24 | November 24th 03 11:43 PM |
| blue foam & cutting it | Richard Riley | Home Built | 6 | November 24th 03 02:53 PM |
| canopy breaking tool? | Russell Duffy | Home Built | 33 | October 1st 03 12:39 AM |
Threaded Mode