Another expensive annual this year

Hi Jay...
Our chapter BOUGHT NEW DIGITAL SCALES last year
and spent 1200 bucks or so on them. 4 pad unit for
race cars, nice stuff. I can't believe the prices folks get to do this.

Scott.


Yikes! $500 is too much. I'd charge $150-$200 plus travel.

And for the EAA guys and Scott above.......
..... well thats great that they BOUGHT NEW DIGITAL SCALES.
I imagine those are the little wheel weighers about 12 inches square and
have a capacity of maybe 1000-1500 pounds. Thats ok for light homebuilts
and ultralights, C152 and Pa140 and such. Fine for you Saturday morning
hobbiests.

But if you consider providing a professional weighing service, you need a
capacity up to 30,000 lbs for each Pad and/or each jackpoint to be capable
of weighing most aircraft used in business.

Shop around for four 30K lb pads and let us know the deals you find.

You also need an annual certified calibration which will cost $300-$400.
Also you might want the capability to generate a nice looking weighing
report on site, and the way I do that is with a laptop and portable printer.
A hand scribbled sheet doesn't look good in a G-IV manual.
There are some other extras that are handy to have, like a set of fuel
hydormeters to measure specific gravity of onboard fuel.
Nitrogen setup to re-adjust gear struts after leveling....... so on.

Btw, someday try rolling a big tire aircraft like a T-6 or T28 up on those
NEW DIGITAL SCALES.

I can certainly believe the prices some folks get to do this!

Kent Felkins
Tulsa Oklahoma