|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
March 31st 04, 08:38 AM
|
|||
|
|||
"Hilton" wrote in message
ink.net... Some engines seem to shake a whole lot less on shutdown when set to 1000 RPM. Then the instruction should be to *set* engine power 1000 RPM before shutting down. Telling a pilot to run the engine at 1000 RPM before shutting down is ambiguous and could (probably will) lead to the pilot simply reducing RPM before pulling the mixture, after running the engine at 1000 RPM. Especially if the instruction is to run the engine at 1000 RPM "for a few moments" (which would clearly imply to reduce RPM again before actually shutting the engine down). Pete 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My Engine Fire!! | [email protected] | Piloting | 21 | April 2nd 04 05:02 PM |
| Starting Engine Question (O-320, Warrior) | Lisa | Piloting | 13 | April 1st 04 06:45 AM |
| My Engine Fire!! | [email protected] | Owning | 1 | March 31st 04 01:41 PM |
| engine overhaul & autopilot question | CriticalMass | Owning | 8 | February 13th 04 06:11 PM |
| Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |
Threaded Mode