|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
February 13th 05, 11:46 PM
|
|||
|
|||
"Steve Waltner" wrote The only torque chart that I'm ever able to find is one for AN bolts/nuts. Since these are aluminum fittings, I don't dare torque them to the same values. Any assistance would be greatly appreciated. Steve This is such basic information, I don't know why anyone needs to ask stuff like this. Everyone knows, you tighten it until it strips, then back off 1/4 turn. I'll go back to my room, now. g Sorry, I had to do it! -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torque values for oil screen | John Clonts | Owning | 2 | January 25th 05 12:01 AM |
| Fuel pump fittings | Evan Carew | Home Built | 15 | October 3rd 04 03:13 AM |
Threaded Mode