|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
January 24th 05, 11:47 PM
|
|||
|
|||
" jls" wrote in message ... "Dick" wrote in message . com... In the past. someone had provided a formula for painting a corkscrew on a prop spinner but I seem unable to find it. Can anyone help as I'd like to paint my new spinner? Thanks, Dick search with barber pole effect spinner Welp, try googling Brian Whatcott who provided the barber-stripe to Pianome. That should get you there. I think I'd like to do that barber-pole stripe thing too. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Paint Stripper? | PETER H. OUELLETTE | Home Built | 9 | November 30th 04 06:12 PM |
| One coat paint for aluminum? | [email protected] | Home Built | 10 | September 17th 04 07:01 AM |
| spinner fab | Dick | Home Built | 5 | April 23rd 04 02:26 AM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |
| Velocity Paint scheme | Ezaviator | Home Built | 0 | July 31st 03 04:09 AM |
Threaded Mode