![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#13
|
|||
|
|||
![]() "Doug Semler" wrote in message oups.com... "Dan Luke" spewed this drivel: "Matt Barrow" wrote: The same day it hit 104 in Chicago and ...the humidity was 90+/- percent. Baloney. Look at a psychometric chart: http://www.rfcafe.com/references/gen...tric_chart.htm Ever hear of "Heat Index"? Yes. What's that got to do with your made-up statement that the temperature was 104 F. and the humidity was 90%? Did you attempt to understand the chart? First off, it's psychRometric. Do you understand relative humidity? According to NOAA, July of 1995 (about which I presume Matt is talking) had the following (from http://www.crh.noaa.gov/lot/science/jul1395/jul1395.htm) quote In the immediate Chicago region, surface dew points held in the upper 70s to near 80 however the temperature exceeded 100 degF for several hours. Heat Index values were greater than 115 degrees for much of the midday and afternoon hours...reaching 125 degrees for the 2145UTC observation from Midway (MDW). In fact, the mercury remained at or above 100 degF at MDW for seven hours, from 13/1800UTC to 14/0100UTC. This extraordinary length may be partially due to the more urban location of the field. /quote Now, I am going to use the following readings: 104 degrees F for the temperature (the "official" high) 80 degrees F for the dew point. According to the formula RH =~ 100((112 - .1T - Td)/(112 + .9T))^8, where T = observed temperature and Td = dew point temperature, I get a relative humidity of 88.32%. P.S. A heat index of 125!?!? That's definitely "stay at home and hope the AC doesn't go out on me" weather! One aspect is that for people outdoors (homeless, for example) cannot get out of the heat during the day (shade doesn't work) nor at night (temps stay high). I suspect that can add to a death toll. -- Matt --------------------- Matthew W. Barrow Site-Fill Homes, LLC. Montrose, CO |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Induction System Water Problem | Mike Spera | Owning | 1 | January 30th 05 05:29 AM |
Any metallurgist's on the group, I want to heat treat aluminum? | [email protected] | Home Built | 3 | December 11th 04 11:50 AM |
Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 12:47 PM |
pitot heat question | K. Ari Krupnikov | Instrument Flight Rules | 7 | December 11th 03 01:51 AM |