|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
July 19th 05, 08:36 PM
|
|||
|
|||
"Doug Semler" wrote: First off, it's psychRometric. Do you understand relative humidity? I thought so, but I foolishly trusted the spelling in the url. Now, I am going to use the following readings: 104 degrees F for the temperature (the "official" high) 80 degrees F for the dew point. According to the formula RH =~ 100((112 - .1T - Td)/(112 + .9T))^8, where T = observed temperature and Td = dew point temperature, I get a relative humidity of 88.32%. We must be looking at different charts. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Induction System Water Problem | Mike Spera | Owning | 1 | January 30th 05 05:29 AM |
| Any metallurgist's on the group, I want to heat treat aluminum? | [email protected] | Home Built | 3 | December 11th 04 11:50 AM |
| Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
| Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 12:47 PM |
| pitot heat question | K. Ari Krupnikov | Instrument Flight Rules | 7 | December 11th 03 01:51 AM |
Threaded Mode