Learning from an owner annual

I used a torque limiting powered screwdriver once on the PK screws into
tinnermans to put my Cessna back together. I learned a lessons after a
flight when several were missing. I use the power screwdriver to run the
screws in and the torque by hand. No problems since.

Ross

wrote:

You know what? I've been through this one so many times, but it's been
a few years, and I just don't have the energy to fight this fight
again.

There is NO "torque-limiting" power screwdriver-type tool that has both
the ability to prevent over-tightening, and allow sufficient "torque"
to be applied to screws installed into aircraft nutplates.

A slightly boogered screw or nutplate will NOT be tightened
sufficiently, or else other screws will be over-tightened-there is NO
middle ground.

In most cases, a quality torque-limiting screwdriver set at minimal
torque can be used by an experienced operator to run screws and
initially secure panels. The final "ginch" needs to be performed by a
human that knows what the **** he/she is doing.

There is a large portion of the "certified technician" population that
isn't smart enuff to use the proper bit for the type of screw to be
r/r'd, let alone to use power to drive it. It's not much of a stretch
to say that this applies to owner-performed maintenance also.

TC