|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
May 29th 06, 05:45 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
structural adhesive
circio0 wrote: Hi everybody! I am looking for a structural adhesive tape but I prefer a glue (because I do not want thickness) to bond aluminium (with passivation or anodization treatment) and steel. The bond have to resist to sea salt fog, and temperature between -100°C +100°C. I will appreciate any suggestions! I suggest you change your design. Unless you are going to attach very small pieces of one to the other, so that differential thermal expansion is negligible, no bonding method is going to work. You could bolt or rivet the parts together and they'd buckle or break. -- FF 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adhesive removal | [email protected] | Soaring | 8 | May 2nd 06 02:37 PM |
| Plexiglas/canopy adhesive | Michael Pilla | Home Built | 3 | May 3rd 04 05:09 PM |
| structural stainless steel tank screws needed for PA-32-300 | Dave | Owning | 11 | October 1st 03 10:14 PM |
| Looking for sand paper rolls and adhesive | Roger Halstead | Home Built | 9 | August 8th 03 08:58 AM |
| Structural adhesive question | BD5ER | Home Built | 1 | August 3rd 03 06:03 AM |
Threaded Mode