![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
![]()
If the TIT is too high, there is not enough fuel flow.
High TIT at high power when the engine is working hard is very destructive. Should be 1350 or so. To get that, you will have to set the pressures at the absolute top end of what Continental recommends. The electronic fuel flow restricts the flow a bit, requiring even higher pressure, which is not widely recoginzed as a problem. Bill Hale BPPP instructor |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turbo Lance MP flux ? | John Doe | Owning | 3 | September 28th 05 01:56 AM |
Why turbo normalizer? | Robert M. Gary | Piloting | 61 | May 20th 05 04:33 PM |
turbo stc? | The Weiss Family | Owning | 21 | October 3rd 04 10:35 PM |
First Time Buyer - High Time Turbo Arrow | [email protected] | Owning | 21 | July 6th 04 07:30 PM |
Partnership Question | Harry Gordon | Owning | 4 | August 16th 03 11:23 PM |