|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
September 23rd 06, 07:12 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Headset Repair componenents
"RST Engineering" wrote in message ... Join-solder the wires to the main cable with shrink over them, then shrink over the both wires, then a large shrink over the whole mess. A large dab of RTV at the center of the junction before you shrink, then the shrink will force the RTV into any voids in the junction. Jim Damn, RTV inside the shrink! Why didn't I think of that. Jim, please explain that again step by step. Which layers of shrink does the RTV go between? I'm thinking of glider trailer wiring. Bill Daniels 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
| Calibrate? Repair? Adjust? | RST Engineering | Owning | 3 | April 4th 05 01:41 PM |
| Panther C.A.T. headset. | Ross Taylor | Products | 0 | October 22nd 04 11:59 PM |
| Canopy crack repair | Pete Brown | Soaring | 0 | May 18th 04 03:09 AM |
| headset plug repair | Michael C Finke | Owning | 14 | February 22nd 04 11:43 PM |
Threaded Mode