|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#25
December 31st 07, 04:47 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
engine pre-oiler
On Dec 31, 9:18 am, "Maxwell" wrote:
"Stuart & Kathryn Fields" wrote in messagenews:uqGdnbOh57S2juTanZ2dnUVZ_qGknZ2d@iwvis p.com... Maxwell: The engine is installed in my Baby Belle helicopter. It has a dry sump located just below the accesory case and a flat plate replaces the normal cast sump which contained the intake manifold. A new intake manifold was constructed, drain tubes made for the valve covers and an oil return was fashioned connected to the accesory case. Works like gangbusters so far (230hrs). If you want I could snap a shot and send them to you via e-mail? That's ok Stu, I have a pretty good idea what your installation looks like. I was trying to picture the installation Dan keeps referring to. None so far. Next time I have the cowling off I'll take some, and then I'll have to set up some account somewhere to post them. Dan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine-out procedures and eccentric forces on engine pylons | Mxsmanic | Piloting | 18 | May 26th 07 01:03 AM |
| Saturn V F-1 Engine Testing at F-1 Engine Test Stand 6866986.jpg | [email protected] | Aviation Photos | 1 | April 11th 07 04:48 PM |
| F-1 Engine for the Saturn V S-IC (first) stage depicts the complexity of the engine 6413912.jpg | [email protected] | Aviation Photos | 0 | April 9th 07 01:38 PM |
| Preheat / Pre-Oiler | Fastglasair | Home Built | 6 | November 13th 04 05:40 AM |
| Preheat / Pre-Oiler | Fastglasair | Owning | 1 | November 11th 04 05:11 PM |
Threaded Mode