|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#32
December 31st 07, 06:28 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
engine pre-oiler
Maxwell wrote:
"cavelamb himself" wrote in message ... KISS! Keep it Simple stupid. AND Lighter is better. Agreed. But what do you suggest would be lighter and simpler? Well, the first question is - does it really NEED a pre-oiler? If it has roller tappets installed, it really doesn't need the preoiler. If it doesn't have roller tappets, I'd add those before adding an oiler. YMMV Richard 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine-out procedures and eccentric forces on engine pylons | Mxsmanic | Piloting | 18 | May 26th 07 01:03 AM |
| Saturn V F-1 Engine Testing at F-1 Engine Test Stand 6866986.jpg | [email protected] | Aviation Photos | 1 | April 11th 07 04:48 PM |
| F-1 Engine for the Saturn V S-IC (first) stage depicts the complexity of the engine 6413912.jpg | [email protected] | Aviation Photos | 0 | April 9th 07 01:38 PM |
| Preheat / Pre-Oiler | Fastglasair | Home Built | 6 | November 13th 04 05:40 AM |
| Preheat / Pre-Oiler | Fastglasair | Owning | 1 | November 11th 04 05:11 PM |
Threaded Mode