|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 12th 08, 01:22 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
control cable protection question
Wanting to use a nylon sleeve over a 1/8" elevator cable to avoid rubbing on
another crossing in mid-fuselage, what do you think about the following methods of securing the sleeve/tube so it doesn't slip out of position: slip sleeve over RTV'd cable section; clamp sleeve ends with safety wire; suggestion... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Saturday 072807 in Oshkosh Pt 5 - the US Customs and Border Protection Blackhawk [4/5] - "04 Blackhawk--rapelling in front of what won't be the World's Busiest Control Tower much longer .jpg" yEnc (1/1) | Just Plane Noise[_2_] | Aviation Photos | 0 | July 31st 07 07:31 PM |
| Control surface design question | Chris W | Home Built | 16 | July 30th 07 04:17 AM |
| Question on Baron 58 prop control | Mxsmanic | Piloting | 62 | December 3rd 06 05:26 AM |
| Can anyone help, PLEASE - searching for zip-cord (aka: mono-cord, speaker wire, shooting wire, dbl hookup, rainbow cable, ribbon cable) | Striker Cat | General Aviation | 0 | October 12th 04 05:11 PM |
| rudder cable question | Bob Loer | Home Built | 7 | November 26th 03 08:34 AM |
Threaded Mode