|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
March 23rd 09, 02:01 AM
posted to rec.aviation.soaring
|
|||
|
|||
What to use to make a mold?
sisu1a wrote:
There's always the option to just trap your lead shot in epoxy thickened with cabosil or microballoons etc, which seems much easier but will obviously not provide the same density as a solid block... It does avoid the breathing of lead vapors, something even a pilot should avoid. -- Eric Greenwell - Washington State, USA * Change "netto" to "net" to email me directly * "Transponders in Sailplanes" http://tinyurl.com/y739x4 * Sections on Mode S, TPAS, ADS-B, Flarm, more * "A Guide to Self-launching Sailplane Operation" at www.motorglider.org 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lyc IO-540 won't make RPM. | [email protected] | Owning | 12 | December 14th 06 10:21 PM |
| How did he make this joint? | Michael Horowitz | Home Built | 4 | September 16th 05 06:14 PM |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 2nd 04 11:15 PM |
| How much does a CFI make? | Peter Gibbons | Piloting | 27 | August 17th 03 02:48 AM |
| $$$'s make right? | Sydney Hoeltzli | Piloting | 9 | July 15th 03 04:54 AM |
Threaded Mode