A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Piloting
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Vne, Va and lift?



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old September 6th 09, 05:49 AM posted to rec.aviation.piloting
Mike Ash
external usenet poster
 
Posts: 299
Default Vne, Va and lift?

In article
,
"Flaps_50!" wrote:

I wonder, does anyone routinely recalculate limiting V speeds on the
basis of TOW? I assume that limiting Va speeds go with the square root
of the fraction MTOW loading so for 75% MTOW Va would drop to 86% Va.
But the question is, if Vne is limited by arodynamic issues such as
flutter or windshield how would that change with load? Put another
way, is Vne ever load dependent and/or does anyone use a rule like
that for Va?


I must admit that I never knew that Va went down, rather than up, with
weight. It makes sense now that I've read about the phenomenon, but this
is the first time I've heard of it.

As for Vne, my understanding of the causes of it (flutter, aerodynamic
loads, etc.) would indicate that it's not dependent on weight at all,
except for how weight might help you get to that speed, but I could very
well be wrong.

A second sort of connected question is: is there any wing that can
produce more lift at 45 degrees AOA than at the stall point (I know
that most airfoils produce about the same lift at 45 AOA as at the
stalling point)? What I'm thinking about is wings with washout or drag
reducing devices that will reduce maximum lift at the stall point but
not the 'flat plate at 45 AOA' lift. Put another way, how much loss of
lift do we get from typical washout?


The coefficient of lift is at its maximum at the stall angle of attack,
by definition. It's not possible for 45 degrees to give the same lift as
stall unless the wing actually stalls at 45 degrees AOA, and that would
be really unusual. Don't know the answer to the washout question, but I
think it would be better framed as how much unnecessary drag is
produced, rather than "loss of lift", which is confusing because a wing
always produces the same amount of lift for a given weight in steady
level flight no matter what the speed, AOA, or wing configuration.

--
Mike Ash
Radio Free Earth
Broadcasting from our climate-controlled studios deep inside the Moon
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
How much lift do you need? Dan Luke Piloting 3 April 16th 07 02:46 PM
Come lift a cup with Joe Rasymas! Fred Soaring 5 October 24th 06 08:42 PM
Theories of lift Avril Poisson General Aviation 3 April 28th 06 07:20 AM
what the heck is lift? buttman Piloting 72 September 16th 05 11:50 PM
thermal lift ekantian Soaring 0 October 5th 04 02:55 PM


All times are GMT +1. The time now is 09:13 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.