![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
![]()
On Jan 20, 11:27*am, Bob Kuykendall wrote:
On Jan 20, 10:10*am, Paul wrote: Would that it were so. I just tried and it told me that my certificate isn't eligible for online update.... Call the number listed in this earlier thread: http://groups.google.com/group/rec.a...wse_frm/thread... Once you reach a human, they'll most likely know exactly what to do. They've been getting lots and lots of calls on this, and it's usually no problem to remove the ATO restriction. It takes just a couple of minutes, then you can go back to the Web site and it goes right through. After that was fixed, the only problem I had with the system was entering a physical address that their system would take. Thanks to the Google, I learned that the USPS considers my neighborhood to actually be part of the zip code for the next town over. Thanks, Bob K. After receiving the "can't do" message on the web site I sent an email to the listed address asking for help, and received one back a few days later stating the problem had been taken care of. It would now appear that the problem was taken care of "for me", but not for everyone else. My mistake was for thinking the fix was for everyone that had glider ratings. Such can be the fun of dealing with the federal government! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proposal: The Steve Fossett Airmans Search Project | Larry Dighera | Piloting | 15 | June 17th 08 07:46 PM |
337 for interior plastic | Robert M. Gary | Owning | 26 | November 28th 05 04:24 PM |
Repairing Plastic | Jay Honeck | Owning | 5 | February 2nd 04 09:20 PM |
New Plastic Certificates... | Ekim | Piloting | 3 | November 28th 03 08:51 PM |
Plastic fender? | Steve Thomas | Home Built | 0 | August 28th 03 04:36 PM |