Intake plenum

On Wed, 07 Apr 2010 22:19:44 -0500, cavelamb ""cavelamb\"@ X
earthlink.net" wrote:

On 4/7/2010 10:04 PM, wrote:
On Wed, 07 Apr 2010 19:56:31 -0400, Ernest Christley
wrote:

wrote:

90 degrees above ambient?

200 max?
That is the minimum required
Can often be a lot hotter than that. Only isophthalic resin rated for
210F and Vynylester rated at 241F would even be close. None of the
common epoxies are rated for that temperature. You would need a
novolac based epoxy (special high temperature epoxy resin)

Thin some JBWeld. Squish it into the glass between sheets of cellophane
with a large socket or piece of pipe.

A BADGE Resin (Bisphenol A DiGlycidyl Ether) resin is another one of
the special high temperature epoxy resins.

Good to about 500

Come on, guys!
How hot do you think the intake air can be and still have the motor run???
I forgot to say JB Weld is a BADGE resin- which is why I mentioned
it.