![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
On Dec 8, 12:46*pm, CLewis95 wrote:
from Paul (sisu1a): ..... *But as I understand it, the pressure at the tail is kinda on a ship by ship basis. Some ships even suck water up the tailpipe when blowing ballast, which is a pretty good indicator of a poor choice for a 'low pressure' location. ... Paul (ALL) I have this problem with my Genesis 2 (both water and "other" fluids). Does this come from a "venturi" effect of air leaking from Horz/Vert Stab Junction or poor Rudder Sealing? *It amazes me how much gets sucked back into fuselage. *(Genesis has VERY short fuselage) Another Genesis owner (DK) has experimented with an exit duct out the fuse hatch over wings. ... comments Don??? Curt - 95 Likely due to pressure recoveing over the very short length of fuselage and large reduction in cross section over that length. High location closer to centerline would probably better in order to avoid effects on root fillet area. Just speculating- It's cold here. UH |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Quiet Vent | Ron (RW) | Soaring | 26 | June 30th 18 04:31 PM |
JS-1 Exhaust Vent | sisu1a | Soaring | 16 | July 27th 10 03:32 AM |
Quiet Vent | Ramy | Soaring | 6 | October 27th 06 05:27 AM |
337 for vent covers? | Robert M. Gary | Owning | 14 | November 12th 05 05:31 PM |
Eye Ball Vent | B. Iten | Soaring | 4 | September 4th 04 09:38 AM |