|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
July 23rd 12, 06:17 PM
posted to rec.aviation.soaring
|
|||
|
|||
Mounting GPS antennas under panel cover
Again, stick with 3M branded.
Good luck, John 3M VHB tape has published specifications, and most of them are rated at 90 lbs/sq. inch tensile, so even at elevated temps. you would probably be OK if you maxed out the area. The fail temperatures are in the 200F to 250F range. Assuming Dual-Lock uses a similar adhesive seems like you would be fine. Brian 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pegasus panel cover | Charles Kotila | Soaring | 0 | June 30th 12 11:07 PM |
| PowerFlarm mounting question, and an idea for mounting devices | brianDG303[_2_] | Soaring | 2 | October 23rd 11 06:51 PM |
| PIREP Needed - Aircraft Door Seals Instrument Panel cover | Mike Spera | Owning | 2 | June 24th 06 05:02 PM |
| Antennas | Terry | Home Built | 3 | April 24th 05 06:42 PM |
| Antennas | Terry | Home Built | 3 | April 22nd 05 03:14 AM |
Threaded Mode