|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
September 14th 12, 04:08 AM
posted to rec.aviation.soaring
|
|||
|
|||
Shortening PowerFLARM Brick Antenna and GPS cables
On Thursday, September 13, 2012 6:21:47 PM UTC-7, (unknown) wrote:
It's probably a lot easier to open the little black box and take a peak at how the cable is soldered at the antenna end. You could probably cut off the excess at the antenna end a lot easier than crimping new connectors. It's a very simple layout. The inner conductor is soldered to one dipole and the shield is soldered to the opposite one. At least the Flarm antenna was done that way and I'd be surprised if the PCAS antenna was any different. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Video of Powerflarm brick in action | Ramy | Soaring | 7 | September 1st 12 12:51 AM |
| Powerflarm Brick feedback | Ramy | Soaring | 7 | August 10th 12 01:02 AM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM 'brick' progress? | Frank Paynter[_2_] | Soaring | 5 | November 13th 11 07:28 PM |
| Display for PowerFLARM brick | Andy[_1_] | Soaring | 4 | May 10th 11 02:32 PM |
Threaded Mode