|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
December 15th 13, 06:12 PM
posted to rec.aviation.soaring
|
|||
|
|||
Air Extractor: Better than a Plastic Jesus?
I added one to my Tetra-15 when I built it. it was really my only solution to vent cockpit air since the tailboom is sealed off aft of the wing T.E.
no arrows to direct the outgoing air, but I can hear it rushing out the vent, so it must work. no hard data for the numbers guys, that being said the guys I fly with in their german glass seem to think the Tetra does just fine, even with a hole in the fuselage. Brad 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plastic Bonding | Urban^nja | Restoration | 2 | September 9th 11 03:57 AM |
| 337 for interior plastic | Robert M. Gary | Owning | 26 | November 28th 05 04:24 PM |
| Repairing Plastic | Jay Honeck | Owning | 5 | February 2nd 04 09:20 PM |
| New Plastic Certificates... | Ekim | Piloting | 3 | November 28th 03 08:51 PM |
| Plastic fender? | Steve Thomas | Home Built | 0 | August 28th 03 04:36 PM |
Threaded Mode