|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
November 17th 14, 08:50 AM
posted to rec.aviation.soaring
|
|||
|
|||
Excessive friction in the aiteron circuit in SZD-55
Hi JJ
I am sorry I did not answer and thanked you for your advice. I think I have not returned to the thread until now. However I am still flying the 55 having put some 500 hours on it since my initial enquiry. Also I had the glider fully refinished, so that may discount the gap. I tend to go against factory advice and wet lube the sliding guides. This has improved the situation.. There is stil more friction that I would like, but mainly at highre speeds. At thermalling speed it is just fine. Once again, thank you for your advice and appologies for not replying more promptly. Six years is a bit long. Cheers paul 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Excessive valve clearance cause low power? | [email protected] | Owning | 16 | October 19th 07 09:11 PM |
| Runway Friction Index | Icebound | Piloting | 15 | April 2nd 06 03:07 AM |
| Shakedown: Friction Lock for Old 172 Mixture Control: $60 | jls | Home Built | 2 | January 30th 04 01:05 AM |
| Throttle friction lock slipping - How do I stop this? | Ron | Home Built | 2 | January 24th 04 12:55 AM |
| Shakespeare Throttle Friction Lock | Larry Smith | Home Built | 3 | November 8th 03 03:01 PM |
Threaded Mode