|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
April 15th 15, 01:46 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm Update Problem
Dan, I disconnected the display this morning and tried upgrading. No joy, same results as described above. I think my PF core has lost the ability to read USB thumb drives. If it wasn't for the mandatory firmware upgrade, I think everything else would be working just fine. Thanks for your tip!
-John, Q3 On Tuesday, April 14, 2015 at 9:57:50 PM UTC-4, Dan Daly wrote: I've found I have 100% success when I disconnect the Butterfly Display, then power up with usb in, and 0% when it is connected (mine is an early core, 169). Once it is done, I reconnect and check it went through. I was a beta tester for 2.7 and it was suggested as a good idea. Adds a couple of seconds but has proven to be a good idea - for me at least. USB 2 less than 32 GB is required for the stick. Dan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM Portable Firmware Update: 6.02 | Paul Remde | Soaring | 15 | April 10th 15 03:13 PM |
| PowerFlarm Update? | Mike the Strike | Soaring | 71 | March 21st 15 05:32 PM |
| I need help with PowerFlarm problem | Andy K | Soaring | 11 | July 23rd 14 09:53 AM |
| Portable PowerFlarm hardware update | kd6veb | Soaring | 8 | March 22nd 13 10:44 PM |
| PowerFLARM Display Update | Paul Remde | Soaring | 2 | November 11th 10 06:40 PM |
Threaded Mode