|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
July 10th 15, 05:58 AM
posted to rec.aviation.soaring
|
|||
|
|||
Gel coat removal - is this okay?!?
JW was a master at anything he touched. Fiberglass, welding, plastics, motors, it did not matter.
That gelcoat was flaking off the wing, it just needed a little encouragement. The pin holes were filled before the poly paint and sanding. The finish is factory perfect, actually better than factory. There are YouTube videos of the glider after the work was completed. It is a joy to fly. You will also find videos of Jim flying his beloved Speed Astir, "UF", hence the Uncle Fuzzy monicker. Jim is surely missed. BillT 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gel coat removal - water sanding vs. straight line sanding | LS3 Pilot | Soaring | 45 | February 15th 10 03:32 PM |
| Gel coat inspection | Matt Keast[_2_] | Soaring | 12 | October 26th 07 09:14 PM |
| Gel Coat Question | Gary Emerson | Soaring | 2 | September 12th 07 11:56 AM |
| Gel Coat for Dummies | Ray Lovinggood | Soaring | 12 | December 24th 04 01:12 AM |
| Gel Coat for Dummies | Ray Lovinggood | Soaring | 2 | December 12th 04 08:15 PM |
Threaded Mode