|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
July 10th 15, 01:14 PM
posted to rec.aviation.soaring
|
|||
|
|||
Gel coat removal - is this okay?!?
On Thursday, July 9, 2015 at 4:32:26 PM UTC-4, Tim Taylor wrote:
Yes, I miss Jim and his inventive ways. I have always thought we should be able to build a gelplane for gliders. Very fine adjustments to allow leaving a thin layer of gel coat but remove the bulk of the material before using the sanders. it would be easier that way! the problem with a "plane" is that the gelcoat/paint thickness is not uniform for several reasons. if you try and take a set thickness off, in some places you'll go through and get into the structure. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gel coat removal - water sanding vs. straight line sanding | LS3 Pilot | Soaring | 45 | February 15th 10 03:32 PM |
| Gel coat inspection | Matt Keast[_2_] | Soaring | 12 | October 26th 07 09:14 PM |
| Gel Coat Question | Gary Emerson | Soaring | 2 | September 12th 07 11:56 AM |
| Gel Coat for Dummies | Ray Lovinggood | Soaring | 12 | December 24th 04 01:12 AM |
| Gel Coat for Dummies | Ray Lovinggood | Soaring | 2 | December 12th 04 08:15 PM |
Threaded Mode