![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
At 02:42 06 March 2016, JS wrote:
Thanks, Clyde. I know that this measurement is done at every Form Two inspection where you live. Until this app, the device was a mark one eyeball, and counting "one, two, three, (etc) while looking at some cheap watch. Then doing it again because you're sure you lost count! The last bit probably won't change until you believe the app can count. Jim On Saturday, March 5, 2016 at 6:01:24 PM UTC-8, IA DPE wrote: In order for this to be recorded in the aircraft logbook, it would have to be a FAA approved measuring device, right? While I can see some value in knowing this reading, there would have to be standardization in the measuring device and technique I would think. 20 years ago we could take a video (including a stop watch) at the wing tip then play it back, in slow motion if preferred. Worked perfectly and it didn't even require a computer. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASH26 wing frequency | [email protected] | Soaring | 9 | August 25th 13 03:27 AM |
Measuring the effectiveness of a sandblaster? | Michael Horowitz | Home Built | 17 | June 14th 09 12:50 PM |
measuring flap angles for rigging | [email protected] | Home Built | 12 | April 28th 06 02:46 PM |
measuring arm distances | Heino & Deanne Weisberg | Home Built | 1 | October 21st 05 05:49 PM |
Metric measuring tool source? | DL152279546231 | Home Built | 12 | April 29th 04 02:13 AM |