![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#17
|
|||
|
|||
![]()
At 07:23 07 March 2016, Steve Thompson wrote:
Suggest instead of opinion - just use the MM for the glider. A very good suggestion. Did a Twin Astir wing frequency check the other week, and that was off by 5 compared to the last measurements. Turns out it somewhat unusually should sit on its wheel and skid (12th item of the annual checklist in the mainenance manual) not on threstles, with a specified tyre pressure of 2.5-2.8 bar. Remeasured and it now was bang on. The way you measure DOES matter. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASH26 wing frequency | [email protected] | Soaring | 9 | August 25th 13 03:27 AM |
Measuring the effectiveness of a sandblaster? | Michael Horowitz | Home Built | 17 | June 14th 09 12:50 PM |
measuring flap angles for rigging | [email protected] | Home Built | 12 | April 28th 06 02:46 PM |
measuring arm distances | Heino & Deanne Weisberg | Home Built | 1 | October 21st 05 05:49 PM |
Metric measuring tool source? | DL152279546231 | Home Built | 12 | April 29th 04 02:13 AM |