![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
![]()
I've concluded that this is the best solution, with one modification - each battery is connected through and ideal diode so there is no cross-charging.. Unlike Schottky diodes, which have on the order of a 0.5 volt drop at typical glider panel currents, ideal diodes have only a 0.03 volt drop up to about 10 amps.
9B On Friday, January 27, 2017 at 12:38:59 PM UTC-8, Charlie M. (UH & 002 owner/pilot) wrote: Nice writeup and diagrams. What I, and others, do is similar to one of yours. Behind the panel, there is a single "common buss" for "+" and "-" that feeds all devices. Feeding that are 2 batteries, each with their own simple on/off master switch. You then have 3 modes of operation: -feed everything from battery 1 -feed everything from battery 2 -feed everything from both batteries at once. There is the previously stated issue regarding batteries at different states of charge, different ages, etc. Plenty of our electronics can display battery voltage or add in a simple panel voltmeter to watch the "device side of the buss" to monitor battery/system voltage. When voltage gets low, turn on the second battery and THEN turn off the first battery so everything remains powered. I like to use screw type terminal strips to make it easier to add/remove devices. These are nice since they've harder to short out..... http://www.mouser.com/ProductDetail/...zIEaApPW8P8HAQ These can be used with ring or fork terminals..... http://www.mouser.com/ProductDetail/...NsEaAm_D8P8HAQ |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power Supply in 98 C182S | [email protected] | Piloting | 1 | April 23rd 07 09:55 AM |
Power Supply in 98 C182S | [email protected] | Owning | 1 | April 23rd 07 09:55 AM |
Power Supply in 98 C182S | Dan[_1_] | Piloting | 12 | April 16th 07 06:40 PM |
Power Supply in 98 C182S | Dan[_1_] | Owning | 12 | April 16th 07 06:40 PM |
WANTING GYRO POWER SUPPLY ???? | Tony | Home Built | 5 | March 7th 06 07:17 PM |