|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#17
July 29th 19, 11:27 PM
posted to rec.aviation.soaring
|
|||
|
|||
Lift pins
OK....stupid question....most FRP works better in tension (from what I know) than compression.
Sooooo.....why is top layer of spar thicker than bottom (I will assume.....yes, I know what assume can mean....) since I will assume bottom of spar has more tension than top (which I will assume is in compression). Not picking, just asking based on your post.... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tapered pins (again) | [email protected] | Soaring | 22 | April 28th 18 03:06 AM |
| Grob 109 wing pins | Bob Jenneson | Soaring | 6 | April 11th 09 10:45 PM |
| ASW-15B spar pins | [email protected] | Soaring | 1 | May 9th 06 12:46 AM |
| Shear Pins for Propellors? | Rich Lemert | Piloting | 25 | April 3rd 05 09:04 PM |
| taper pins | Ernest Christley | Home Built | 4 | September 12th 03 03:15 AM |
Threaded Mode