|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
September 5th 19, 04:48 PM
posted to rec.aviation.soaring
|
|||
|
|||
Wiring Harness Needed
simple enough to make using a db15 connector. You should check the manual for your particular serial number radio to be sure nothing has changed but for mine the pinouts are as follows:
+12v - pins 4, 5 Ground - pin 2 PTT switch - pin 12 PTT ground - pin 3 Audio Ground - pin 9 Audio signal - pin 15 Mic in - pin 11 Mic ground - pin 10 All ground lines (2, 3, 9, 10) are tied together internal to the radio. All +12v lines (4, 5) are also tied together internal to the radio. Robert On Wednesday, September 4, 2019 at 3:36:42 PM UTC-5, Bob Youngblood wrote: I have a radio that needs a wiring harness, Becker AR3201 can anyone help. Thanks, Bob 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| looking for Hooker harness | Al MacDonald | Home Built | 0 | July 12th 08 03:54 PM |
| engine monitor wiring harness install | Jim Burns | Owning | 8 | November 20th 06 02:26 PM |
| S-H safety harness (V2C) | [email protected] | Soaring | 20 | April 28th 06 08:54 AM |
| Harness | Nolaminar | Restoration | 2 | December 25th 03 03:04 PM |
| Narco AT-50A Wiring Diagram Needed | Jerry | Aviation Marketplace | 0 | August 3rd 03 11:07 PM |
Threaded Mode