![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
George, I will show/send your posting to some of the Embry Riddle kids we have flying at our winch only club here in Prescott AZ. Not sure if any, about 5 currently, are Aerodynamicists, but they may be interested.
Cliff Hilty CFIG Prescott Area Soaring CH ASW27 |
#2
|
|||
|
|||
![]()
On Saturday, October 5, 2019 at 7:53:50 AM UTC-7, wrote:
George, I will show/send your posting to some of the Embry Riddle kids we have flying at our winch only club here in Prescott AZ. Not sure if any, about 5 currently, are Aerodynamicists, but they may be interested. Cliff Hilty CFIG Prescott Area Soaring CH ASW27 Cliff, Thank you very much. Even if they don't have the needed skills or interest, they may know other students that do/are or may run it by a facility member. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Winch Launch - Fatal | Jock Proudfoot | Soaring | 65 | December 19th 16 08:57 PM |
Winch Launch Fatality | Ed Gaddy[_2_] | Soaring | 3 | June 23rd 09 11:15 PM |
LIppmann reports a 950 meter winch launch with their Dynatec winch line - anything higher? | Bill Daniels | Soaring | 20 | December 27th 04 12:33 AM |
Winch Experts wanted | Ulrich Neumann | Soaring | 117 | April 5th 04 06:52 AM |
Winch launch | M B | Soaring | 0 | October 30th 03 07:33 PM |