Js3 jet catastrophic failure.

On 10/27/20 10:41 AM, wrote:
I really like what Chris has done and have reached out to him. What's on my mind is two 40kg class engines. You would have 175lbs of thrust, and in the event of one failing, you still have an adequate sustainer. I'm estimating the system would be around $25,000 (15k for the engines and 10k for the install). Where I am guessing entirely is the cost of the install, and if there would be enough room for two of this size engine. Two P300s are 10.5" wide next to each other, while two 40kg motors would be 11.5". So it seems they would fit in a lot of cases.

Interestingly, the P300 has a bit of a track record of catastrophic failure. I'm sure there is an explanation out there as to why, but I followed many incident threads and I never found a definitive answer. There was speculation that the rotor sizing resulted in a resonant frequency that was causing stress on the bearings.


There were a lot of jets on display at the 2018 SSA convention, here's a
1-26 side by side installation that had a really slick single lever
retraction mechanism (FB required):

https://www.facebook.com/AuxiliaryPo...1828046778122/

But as I've told Chris, I don't think the future of motorgliders is
jets, high fuel consumption, they're loud, and not all that reliable.
Flying with JS-1 and -3 sustainers, the reliability hasn't been that
great. Chris landed his HP-18 out from my home airport, ran out of fuel
after a self-launch and short self-retrieve. Might as well go with a
Silent 2 FES if you're happy with that type of range.