|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
November 30th 20, 05:28 PM
posted to rec.aviation.soaring
|
|||
|
|||
Identifying a Canopy Blank's Glider Model
On Sunday, November 29, 2020 at 8:23:06 PM UTC-8, John DeRosa OHM Ω http://aviation.derosaweb.net wrote:
The window opening is 6-1/2" x 4-1/2". Hi John, It’s all in the curve......side view? Best way to check is to lay it over another ship. Yours is a good 10” longer than say the Standard Cirrus which is 68” long. I’d lay it over a DG and see how that looks. For reference the Standard Cirrus measurements a Rear H -16”. Mid point H- 16”. Nose H- 8” W- 24”. W-23”. W-20” Overall length 68” Hope this helps, JJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| glider canopy | Morris Carter | Soaring | 7 | February 13th 20 11:13 PM |
| Escaping glider on the ground with stuck canopy? | Steve Koerner | Soaring | 27 | May 21st 19 04:06 AM |
| Std Libelle Low profile canopy blank | [email protected] | Soaring | 0 | November 7th 15 09:35 PM |
| Where to get a glider canopy in the US | Bob Kuykendall | Soaring | 0 | September 4th 08 01:16 AM |
| Glider Model - Blaue Maus- 1922 Wasserkuppe Glider | [email protected] | Soaring | 5 | November 19th 06 11:08 PM |
Threaded Mode