|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 19th 03, 03:36 PM
|
|||
|
|||
"aptim" wrote in message ... I was told in A&P school that It stands for Parts Manufactured Approved. Parts Manufacturer Approval. 
|
|
#2
November 19th 03, 05:36 PM
|
|||
|
|||
|
Nope. Parts Manufacturing Approval
Jim "Ron Natalie" shared these priceless pearls of wisdom: - -"aptim" wrote in message ... - I was told in A&P school that It stands for Parts Manufactured Approved. - -Parts Manufacturer Approval. - - Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com
|
|
#3
November 19th 03, 06:04 PM
|
|||
|
|||
|
"Jim Weir" wrote in message ... Nope. Parts Manufacturing Approval "Ron Natalie" shared these priceless pearls of wisdom: -Parts Manufacturer Approval. Sorry, Jim. I disagree. While the FAA abuses the term term as "manufacturing" in a few advisory circulars. The term is "manufacturer" in both the FAR (Part 21, subpart K) and in order 8110.42A (the PMA process itself).
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
