A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Owning
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Burning out a Magneto Drop



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #7  
Old February 28th 04, 06:22 PM
jls
external usenet poster
 
Posts: n/a
Default


"C J Campbell" wrote in message
...

" jls" wrote in message
...

Leaning an engine takes a little finesse. It shouldn't be done on the
ground unless you're in Denver or on a high-altitude ramp. A small

fraction
of that fuel charge is cooling your heads as it evaporates and flows

through
the combustion chamber and out the exhaust port. Ideally it is rich

enough
to give you a perfect stoichiometric charge plus just a little for

cooling.
If you burn it all by leaning you have lost your mixture's ability to
dissipate heat. In addition, some of a lean charge is burning as it
departs the combustion chamber because a lean mixture burns more slowly

than
a rich one. Damned if I want my exhaust valve to glow just to clean a
sparkplug.


I think you are exaggerating.


Yeah, I don't know if the exhaust valve glows or not but I know when one
gets too hot and don't plan to let it happen to my engine.

More than a little bit. I guarantee that even
at sea level you are going to get spark plug fouling if you do not lean

your
engine somewhat during taxi -- especially when taxiing in. You just
completed a descent with the mixture full rich and the engine idling --

lots
of cooling and plenty of opportunity for spark plug buildup.


I don't see any big problem with leaning as you taxi. We lean sometimes on
descent and will often lean if an engine tends to miss or surge. It
depends on the engine and airplane too. Leaning at idle, or close to it,
as in when you are taxiing, won't fry your cylinders. But leaning at high
static rpm's will, sooner or later. Thus the reason for TCM's advice not
to do it.

I suspect that
the detonation and premature ignition that result from your

recommendations
are even harder on an engine than occasionally clearing a spark plug.


Explain what recommendations I have given which will cause detonation and
premature ignition. Fuel of the improper octane, engine hot spots,
improper leaning and engine conditions I am generally opposed to cause
detonation and preignition. See, e. g.,
http://www.sacskyranch.com/eng180.htm


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Burning out the pitot heat? Mitty Instrument Flight Rules 3 December 30th 04 05:04 AM
Drop in and say hello Gilan Home Built 0 June 4th 04 05:12 PM
Economist: Let the dollar drop Luca Morandini Military Aviation 5 February 14th 04 05:58 PM
:-) let enola gay drop one more :-) old hoodoo Military Aviation 3 December 28th 03 05:39 PM
Ellery Queen and the Case of the Missing Magneto Gear Teeth MikeremlaP Owning 3 July 26th 03 03:01 AM


All times are GMT +1. The time now is 10:40 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.