|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 7th 04, 09:44 PM
|
|||
|
|||
Do you try to remove the existing stuff, or just goop it on over
whatever is there now? What prep do you do to the existing surface? None. I just painted over the wing-walk that was already there. If done properly, wing walk is very thin. By the time you get around to re-doing it, it'll be even thinner. (In my case, there were a couple of pencil-eraser-sized bare spots.) The stuff paints on easy, and has stood up well. -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" "Bob Fry" wrote in message ... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| more radial fans like fw190? | jt | Military Aviation | 51 | August 28th 04 04:22 AM |
| Osan’s 51st Fighter Wing to get its own coin | Otis Willie | Military Aviation | 0 | April 5th 04 10:44 PM |
| ANG Woman Wing Commander Doesn't See Herself as Pioneer, By Master Sgt. Bob Haskell | Otis Willie | Military Aviation | 0 | March 18th 04 08:40 PM |
| Props and Wing Warping... was soaring vs. flaping | Wright1902Glider | Home Built | 0 | September 29th 03 03:40 PM |
| Can someone explain wing loading? | Frederick Wilson | Home Built | 4 | September 10th 03 02:33 AM |
Hybrid Mode
