|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 2nd 04, 10:39 PM
|
|||
|
|||
Not a dumb question at all. You can use a sand hourglass if you want, just so
long as you use the same method all the time. That is, use hobbs OR tach OR wris****ch, just be consistent. No, the regs do not REQUIRE you to use the same method every time, but you'll play hell explaining your method to the FAA if they come a'snoopin'. Jim "O. Sami Saydjari" shared these priceless pearls of wisdom: -OK, dumb question. For 100-hour inspections (or 50 hours until oil -change), is this measured in Hobbs time or Tach time? - --Sami -N2057M, Piper Turbo Arrow III Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| American nazi pond scum, version two | bushite kills bushite | Naval Aviation | 0 | December 21st 04 10:46 PM |
| FS: 2002 "Ghosts: A Time Remembered" (Aviation) Calendar | J.R. Sinclair | Aviation Marketplace | 0 | June 14th 04 06:22 AM |
| FS: 1990 Cracker Jack "War Time Airplanes" Minis 6-Card (CJR-3) Set | J.R. Sinclair | Aviation Marketplace | 0 | April 12th 04 05:57 AM |
| "I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
| It's that time of year again. | Capt. Doug | Home Built | 19 | September 3rd 03 10:53 PM |
Hybrid Mode
