|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 11th 04, 08:26 PM
|
|||
|
|||
Had a similar problem on my Arrow a couple of years ago one bitter
cold morning - went up to 3000 RPM, then back to 2700 but no audible change in the engine. I just decided (#*$& with this technology and installed a digital tach. In addition to getting perfectly accurate readings, the digital unit (Horizon) also monitors both mags continuously. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best lubricant for Mechanical Tachometer Cable??? | RonLee | Home Built | 3 | January 4th 05 12:04 AM |
| Can anyone help, PLEASE - searching for zip-cord (aka: mono-cord, speaker wire, shooting wire, dbl hookup, rainbow cable, ribbon cable) | Striker Cat | Home Built | 6 | October 15th 04 08:51 PM |
| Wayward Tach | O. Sami Saydjari | Owning | 7 | February 6th 04 01:27 AM |
| Tach Vs. Hobbs Time | John Roncallo | Owning | 33 | January 7th 04 12:42 AM |
| Rudder cable - was The Little Wheel in Back | BD5ER | Home Built | 9 | September 11th 03 04:14 PM |
Hybrid Mode
