|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 22nd 04, 09:35 PM
|
|||
|
|||
"Jay Honeck" wrote in message news:cI9od.66570$V41.11973@attbi_s52...
Our JPI EDM-700 engine analyzer may have paid for itself today. Here's the scenario: snip Your tests have pretty well narrowed it down to a plug that isn't firing (the 1st thing I look for when EGT shoots up on one cyl.). It's unlikely that the mag is firing well on all but one cyl. The most likely causes are a plug wire or the plug itself. If your mech is equipped with good testing gear, he should be able to isolate the problem pretty quickly. John Galban=====N4BQ (PA28-180) 
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
