|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 6th 05, 01:20 PM
|
|||
|
|||
On Sun, 6 Feb 2005, Dick wrote:
propane torch heating slightly the scratches to "erase" them. I was Well, You must know that you can sand out the scratches, and save the canopy. However, it may be more work than it's worth. So long as you are prepared to purchase another, and they are available, why not experiment. I've seen scratch remover sold for eyeglasses that I'd try first. I cannot imagine the torch idea leaving a clear view through the canopy, and removing the waves is as much work as removing the scratches. George Graham RX-7 Powered Graham-EZ, N4449E Homepage http://bfn.org/~ca266 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| molding plexiglas websites? | [email protected] | Home Built | 13 | February 6th 05 09:26 PM |
| Would you like to write about your hobby for one of the UK's top websites? | Steve Roche | Home Built | 0 | February 13th 04 10:36 AM |
| Zenith Ch 701 Builder's info and websites?? | DL152279546231 | Home Built | 1 | February 10th 04 08:21 PM |
| homebuilder websites updated daily? | Joa | Home Built | 6 | December 28th 03 07:30 PM |
Hybrid Mode
