|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 9th 03, 02:43 AM
|
|||
|
|||
On Sat, 8 Nov 2003 18:30:36 -0800, "BTIZ"
wrote: I put the receiver back in, and had my mechanic put the loop antenna back on the plane during annual. well.. there's your problem right there.. your mechanic may not be a "radio repair shop".. BT Maybe so.... I didn't think it was really a tough job..... The wiring and connector jack was already in place. All the mechanic had to do was clean out the connector already in place, screw in the two screws, and seal it with RTV. If a mechanic can't screw in two screws.......... dp 
|
|
#2
November 10th 03, 03:01 AM
|
|||
|
|||
|
If a mechanic can't screw in two
screws.......... Oh, he can screw in the screws alright, but can he get the right wire in the right hole? Peter
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
