|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 5th 04, 06:43 PM
|
|||
|
|||
In article ,
" jls" wrote: "Paul Anton" wrote in message ... not we'll have to go to the next oversize set of pushrods and our budget is already busted all to hell. TIA and bless you. They aren't all that expensive. Try Fresno Airparts. Cheers: Paul NC2273H Thanks, Paul, and you're right. Fresno has them for $22.50 as opposed to $85 apiece from another source. Have you tried El Reno Aviation? I believe that the O-290 uses the same pushrods as the O-435. Both engines use the same pistons, cylinders, rods, valve train. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Q: Disecting a cut-off valve? | Michael Horowitz | Home Built | 0 | March 6th 04 01:47 PM |
| OK, all you limeys: 4 beautiful chromium-plated valve covers for Continental O-200 | jls | Home Built | 5 | February 10th 04 05:36 PM |
| Airplane Parts on Ebay Vac Reg Valves, Fuel Floats, O-200 Spider, Fuel Injection Valve | Bill Berle | Home Built | 0 | January 26th 04 07:48 AM |
| Fuel Selector Valve | Jay | Home Built | 5 | November 15th 03 11:16 PM |
Hybrid Mode
